PoolControl 2 ECO - Version 2

Standard PoolControl2 - App control
Power supply 230v mono, Max 16A, 3680Watt

  • Pool cover control up to 240W, speed infinitely adjustable.
  • Output LED lighting 12v 35w. (ww or Multicolor) (150w for "AP" versions)
  • Output for 3f 240v Filterpump.  (+ control on cabinet door)
    • Stepless speedcontrol by frequency converter
    • Control output automatic backwash (Potential-free contact NO).
  • Pool Water heating control.
    • Frost protection
    • Control output heating appliance (Potential-free contact NO).
    • Control output water-flow solar panels (Potential-free contact NO).
    • Input PT1000 Water temperature (temp. sensor).
    • Input PT1000 air temperature (temp. sensor).
  • Input for water level monitoring. (float)
    • Water valve output Potential free contact.


Options:
  • Remote control 2 channels (cover, LEDs). (Order code: RCSETPC2)
  • 4 x additional outputs that can be freely used (Order code: RELSETPC2)
    • configured and controlled in the app

Version 2 of the PC2ECO control box has a switch added on the unit's door to quickly control the filter pump. (Continue / OFF / AUTO-APP)

If the type designation of your PoolControl ends with "AP", for example "PC2-V2-AP" or "PC2ECO-AP", that means your PoolControl is equipped for heavier lighting.
Up to 150W.

Please, keep in mind that the PC2 and PC2ECO need a hardware (RJ45) connection to the internet to be able to control it from you mobile phone


Click the PDF to find out more about the different ways to get internet to you PoolControl2.
PC2 Internet connectio guide.pdf

Before you start!
Set the filter pump's thermal safety to the nominal current marked down on the ID-plate of the pump's motor. ("In" or "A")

A little side note: A 230V UV-lamp can be connected to terminals 3 & 4 Along with the 230V Filter pump.
If you do so, please remember to reset the filter pump's thermal safety to the nominal current of the filter pump + nominal current of the UV-lamp.

Quick Connection guide

A4 Connection Guide Sticker PC2ECO.pdf

Using your heathing trough Heat exchanger or similar? This is how you connect it

PC2ECO heating with circulation pump.pdf

Overview Components PC2 Eco

PC2ECO Cheat Sheet T&A.pdf

Electrical schematics

PC2ECO-V2.pdf

PT1000 Temperature sensors used for PC2

PT1000

PT1000

Trouble shooting PT1000:

You can measure the resistance of the sensor with an Ohm-meter.
A good PT1000 will show +/-1000Ω at 0°C, +/-1039 at 10°C, +/-1078 at 20°C, +/-1117 at 30°C
Klick here for the complete temperature vs resistance value table.

Frequency Converter Speed settings.

PC2ECO Drive speed setting manual.pdf

App Manual

PC2 App Manual.pdf

App password reset after pool startup. (Dealers / Technicians)

PC2 Dealer logon-reset procedure.pdf

Help video