PoolControl 3
With Build-In display
PoolControl 3
With Build-In display
Standard PoolControl3
Power supply 230v mono, Max 16A, 3680Watt
If the type designation of your PoolControl ends with "AP", for example "PC3-AP" or "PC3ECO-AP", that means your PoolControl is equipped for heavier lighting.
Up to 150W.
To control PC3 and PC3ECO trough the App, PC3 needs a hardware (RJ45) connection to the internet to be able to control it from you mobile phone
Before you start!
Set the filter pump's thermal safety to the nominal current marked down on the ID-plate of the pump's motor. ("In" or "A")
A little side note: A 230V UV-lamp can be connected to terminals 3 & 4 Along with the 230V Filter pump.
If you do so, please remember to reset the filter pump's thermal safety to the nominal current of the filter pump + nominal current of the UV-lamp.
Set the Thermal safety by turning the wheel to the value found on the Filter pump's motorID-plate.
Motor ID-plate example.
This message will appear in the app after the Therminal safety for the filter pump activates.
PC3 can control VS-Pumps (Filter pumps with the frequenty drive build-in) trough our optional relais-set (RELSET) with a jumper to alter the function of the RELSET
Please refer to the documentation on the right ->
PT1000
PT1000
Trouble shooting PT1000:
You can measure the resistance of the sensor with an Ohm-meter.
A good PT1000 will show +/-1000Ω at 0°C, +/-1039 at 10°C, +/-1078 at 20°C, +/-1117 at 30°C
Klick here for the complete temperature vs resistance value table.