PoolControl One S
PoolControl One S
PoolControl (Currently not available)
Power supply 230v mono, Max 16A.
If the type designation of your PoolControl ends with "AP", for example "PCONE-AP" or "PCECO-AP", that means your PoolControl is equipped for heavier lighting. Up to 150W.
Before you start!
Set the filter pump's thermal safety to the nominal current marked down on the ID-plate of the pump's motor. ("In" or "A")
A little side note: A 230V UV-lamp can be connected to terminals 3 & 4 Along with the 230V Filter pump.
If you do so, please remember to reset the filter pump's thermal safety to the nominal current of the filter pump + nominal current of the UV-lamp.
Set the Thermal safety by turning the wheel to the value found on the Filter pump's motorID-plate.
Motor ID-plate example.
PT100
(Covrex order code: 515-405)
Self adhesive PT100
Trouble shooting PT100:
You can measure the resistance of the sensor with an Ohm-meter.
A good PT100 wil show +/-100Ω at 0°C, +/-103.9 at 10°C, +/-107.8 at 20°C, +/-111,5 at 30°C
Klick here for the complete temperature vs resistance value table.